Amarillo Pavement Pros: Parking Lot Resurfacing Cost in Amarillo, TX: Overlay Prices
Amarillo Pavement Pros puts numbers on parking lot resurfacing in Amarillo, TX, and on the work that comes with it. Every figure is a national cost-guide figure with its source named. None is a Panhandle rate and none is a quote. What the figures are good for is telling you whether a resurfacing budget is a five figure line or a six figure one before anybody prices the lot.
Resurfacing is an overlay by another name
To a paving contractor, resurfacing means "overlay": a new layer of hot mix asphalt over the lot you already have, laid either straight onto the old surface or after part of it has been ground away. It is not a coating, and it is not digging the lot out and starting again; much of the confusion between bids comes from all three travelling under one word.
The two resurfacing prices
| Work | Range | Source |
|---|---|---|
| Overlay on a structurally sound lot | $3 to $6 per sq ft | Asphalt Repair Solutions, 2026 |
| Mill and overlay | $4.50 to $7.50 per sq ft | Wright Construction, 2026 |
| Milling on its own | $1.50 to $3.00 per sq yd | Engineer Fix |
A straight overlay puts new asphalt on top of the old surface and raises the grade by the thickness of the lift. A mill and overlay grinds a matching depth off first, so the finished surface sits where the old one did. The gap between the two rows is mostly the milling, the hauling and the tack coat.
Which one a lot needs is not a matter of taste. Where a higher surface would bury a curb, leave a step at a doorway, block a drainage inlet or put a lip on an accessible route, the lot gets milled. Most commercial lots have one of those somewhere. How the grinding works is covered on the asphalt milling page.
What a 10,000 square foot lot comes to
Each rate times ten thousand square feet, with nothing added:
| Project, 10,000 sq ft | Range |
|---|---|
| Overlay | $30,000 to $60,000 |
| Mill and overlay | $45,000 to $75,000 |
| Full-depth reconstruction, for comparison | $80,000 to $150,000 |
The last row is where a resurfacing job ends up when it waits too long; the distance from the first row is the price of waiting.
Not sure whether your lot is an overlay or a mill and overlay? Describe the curbs, doorways and drains, and ask which one the lot needs before comparing bids.
Call (806) 375-4850Line items that sit outside the square foot rate
Three kinds of work usually sit beside an overlay on a proposal, and they explain most of the gap between two bids.
Patching before the lift. New asphalt over a soft spot fails in the same footprint. Areas where the base has gone are cut out and rebuilt first, at $6 to $12 per sq ft for a full-depth patch, against $3 to $5 per sq ft for a surface patch where the base is sound (both We Love Paving, 2026). A bid that does not say how much patching it carries has not really priced the lot.
Crack sealing. Cracks in the old surface tend to work their way up through a new lift over time, which the trade calls reflective cracking. Sealing the worst of them before paving is priced by length, at $0.75 to $3.00 per linear ft (Engineer Fix).
Markings. Resurfacing erases every stall line, arrow and fire lane. Restriping a small to medium lot runs $300 to $1,500 per lot (Walt's Paving). Parking lot striping goes back down as part of the same project, so it belongs in the same budget. Repainting an accessible stall costs $250 to $900 per stall, and on a stall that has settled out of the 1:48 slope limit the paint alone still fails. Drainage correction is quoted per lot; no cost guide publishes a figure for it.

Why the clock runs faster on the Llano Estacado
The rates above are national. The speed at which a lot slides from one row to the next is local. Amarillo sits at 3,606 feet, and NOAA's Engineering Weather Data for the Amarillo station (1973 to 1996 record) averages about 85 freeze-thaw cycles a year. Each cycle freezes whatever water has found its way into a crack and lets it thaw again, and each one pries the crack a little wider. That is how a clean overlay candidate in spring becomes a patching job by the following winter. The Amarillo pavement weather page has the rest.
The same reasoning holds fifteen miles south. Commercial lots in Canyon sit on the same caprock through the same winters, so an Amarillo resurfacing budget carries over, though Canyon's own permitting is confirmed with the City of Canyon.
How many years the money buys
Price per square foot is half the comparison; the other half is how long the new surface lasts. National guides put a properly built overlay at 8 to 15 years with proper maintenance, and full replacement at 20 to 30 (Wright Construction, 2026). Where an overlay lands in that spread depends more on what happens afterwards than on what was paid. Crack sealing and sealcoating on a cycle are what push an overlay toward the long end.
When the budget crosses into state review
At these rates, resurfacing a mid-sized lot can pass $50,000. Under Texas Government Code chapter 469, plans for a project with an estimated construction cost of $50,000 or more must be submitted to the Texas Department of Licensing and Regulation before a building permit is applied for or construction starts, and the finished work must be inspected within a year of completion. Below that line, TDLR says the work must still comply with the Texas Accessibility Standards. The state's project registry is public, and an Amarillo search for "parking" in the project name returns dozens of projects, from accessible parking upgrades to entirely new lots. The ADA parking compliance page covers what that review looks at.
Reading a resurfacing bid
Check that each proposal states:
- the area in square feet, and whether it is an overlay or a mill and overlay
- the lift thickness after compaction, and the milling depth if any
- how many square feet of full-depth patching are included, and where
- whether crack sealing before paving is included
- what happens to the striping and the accessible stalls
- what is excluded, drainage work in particular
Two bids that answer all six can be compared on price. With those numbers in hand, choosing an asphalt overlay contractor in Amarillo becomes a decision about the work rather than a guess about it.
Questions about a piece of ground near Amarillo? Call (806) 375-4850
Frequently Asked Questions
Parking Lot Resurfacing Cost in Amarillo, TX: Overlay Prices: Questions
How much does it cost to resurface a parking lot?
National guides put an overlay on a structurally sound lot at $3 to $6 per sq ft and a mill and overlay at $4.50 to $7.50 per sq ft. For a 10,000 sq ft lot that is $30,000 to $60,000 or $45,000 to $75,000, before patching, crack sealing and restriping.
Is resurfacing the same as repaving?
Not usually. Resurfacing lays a new layer over pavement that stays in place. Repaving is often used to mean taking the old pavement out and building it again, which is reconstruction, at $8 to $15 per sq ft (Wright Construction, 2026) against $3 to $6 per sq ft for an overlay. Ask every bidder which one the word means on their proposal.
Can a lot be resurfaced more than once?
Yes, while the base stays sound. Each mill and overlay replaces the worn top layer. Once water has softened the base across the lot, another lift copies the failure, and rebuilding is the honest answer.
Does a resurfacing project need TDLR registration?
Under Texas Government Code chapter 469, a project with an estimated construction cost of $50,000 or more must have its plans submitted to TDLR before the building permit or construction, and an inspection within a year of completion. A smaller job still has to meet the Texas Accessibility Standards.
Are these prices specific to Amarillo?
No. They are national cost-guide figures with the source named beside each one. Ask for a written price before work starts, with the quantities on it.
